Hucker – This is someone that throws him or herself wildly into and through the air without landing on their feet. Iguana Air – This is what you have when the rear hand is grabbing the toe edge of the board near to the tail of the board. Indy Air – This is performed on [...]
Online Stores- Husqvarna Riding Mowers Lawnmowers Yard, Garden & Outdoor Living Nursery
- Big Candy Stripe Jump Ropes Fitness Equipment Gym, Workout & Yoga Exercise & Fitness
- Front Load Washers & Dryers Major Appliances
- Mulching Riding Mowers Lawnmowers Yard, Garden & Outdoor Living Nursery
- Board Decals, Patches & Stickers Surfing Surf Store
Related Posts -
Snowboarding Glossary Continued Gap - This is essentially like a tabletop that does not have snow in the middle, or similar to a jump that has a ramp for taking off that is higher up than the table down below it. A gap is described as the distance or the space that exists...... -
Snowboarding Glossary Continued Sad Plant - This is a term that is used to describe any type of hand plant where the rider is boning the front leg for the purpose of style. Sandwich Construction - This is a term that is used to describe layers of materials that are layered on top...... -
Snowboarding Glossary Continued Swiss Cheese Air - This is a term that is used to describe a situation where the rear hand is reaching between both legs, grabbing the board's heel edge before the front foot while boning the back foot. Switch - This is a term that is used to describe any...... -
Snowboarding Glossary Continued Poptart - This involves airing from fakie side to forward side while in the half pipe without any rotation. Poser - This is someone that behaves as if they are better than they actually are. Pre-Peg Fiberglass - This is a stiff piece of fiberglass that is treated using epoxy...... -
Snowboarding 101 - Switching the Edge Another one of the most important tips and techniques that you can learn when it comes to learning how to snowboard is switching edges. If you should happen to find that you are on the wrong edge of your snowboard, then what you normally have to do is to unfasten......
