Hucker – This is someone that throws him or herself wildly into and through the air without landing on their feet. Iguana Air – This is what you have when the rear hand is grabbing the toe edge of the board near to the tail of the board. Indy Air – This is performed on [...]
Online Stores- Big Candy Stripe Jump Ropes Fitness Equipment Gym, Workout & Yoga Exercise & Fitness
- Husqvarna Riding Mowers Lawnmowers Yard, Garden & Outdoor Living Nursery
- Mulching Riding Mowers Lawnmowers Yard, Garden & Outdoor Living Nursery
- Board Decals, Patches & Stickers Surfing Surf Store
- Front Load Washers & Dryers Major Appliances
Related Posts -
Snowboarding 101 - Switching the Edge Another one of the most important tips and techniques that you can learn when it comes to learning how to snowboard is switching edges. If you should happen to find that you are on the wrong edge of your snowboard, then what you normally have to do is to unfasten...... -
Snowboarding Glossary Continued Swiss Cheese Air - This is a term that is used to describe a situation where the rear hand is reaching between both legs, grabbing the board's heel edge before the front foot while boning the back foot. Switch - This is a term that is used to describe any...... -
Snowboarding Glossary 180 - While in the air a rider makes a 180 degree turn and will land fakie, except for riding in a half pipe where a 180 will bring the nose around to face forward again. 360 - While in the air the ride makes a 360 degree turn, which...... -
Snowboarding Glossary Continued T Bolt - This is a term that is used to describe a small metal cylinder that is threaded inside and that has a disk attached to its bottom, which will prevent it from being pulled up and away from the snowboard. Technical - This is a term that is...... -
Snowboarding Glossary Continued Lien Air - This involves the front hand grabbing the board's heel edge, and the snowboarder's body leans out across the nose of the board. This is essentially a method used on the front side wall. Lien Method Air - This is a combination between a Lien and a Method.......
